Difference between revisions of "User:Qazaaq"

From the Oblivion ConstructionSet Wiki
Jump to navigation Jump to search
imported>Qazaaq
(How to Write Qazaaq properly)
imported>Qazaaq
(i'm also a modeller :))
Line 18: Line 18:


[[Category: Users: Scripters|Qazaaq]]
[[Category: Users: Scripters|Qazaaq]]
[[Category: Users: Modellers|Qazaaq]]

Revision as of 17:44, 24 November 2007

How to Write Qazaaq

It's Qazaaq: Q-A-Z-A-A-Q, not Qazaq or Quazaag.

It's actually very easy to write Qazaaq, you only need three letters, which is a very low avarage. You don't even need to use your right hand if you don't begin with a capital. This is not encouraged or recommended and should only be done in emergencies.

Let's start at the Q, a capital letter.

 To produce a capital letter press and hold shift while typing the letter in question.

The Q is the only capital so you don't have to press the shift key again to write the rest of my name. Move your left hand or finger down to the a key and press it once. We will return to this key later in this tutorial.

Now move your left hand or finger down again to the z key and press it once, just like the a key. You've just finished writing half my name, good job! There are still three letters to go, let's move on.

Move your hand or finger up and back to the a key again. To produce the double a in Qazaaq you have to press this key twice. We end this tutorial with the same letter we began, the q. Notice this q is not a capital; don't hold shift while typing this letter. Press the q key once to finish writing Qazaaq.

Congratulations, you've successfully written my name! Like almost any word, Qazaaq is followed by a space in most cases, there are a few exceptions like when ending a sentence or using a punctuation mark like : or ;. That will not be covered in this tutorial.

See Also

Qazaaq's profile @ BSF